Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Sweep Across Midwood
Midwood homeowners call us because the chimneys here are older than most of the equipment people put into them. The housing stock is overwhelmingly pre-war, and a lot of these flues have never been properly swept, lined, or capped. We’re Chimney Sweep Canarsie, and Midwood is part of our regular service area, so we know the housing here well. A sweep without an inspection is a missed diagnosis, which is why every visit starts with a camera. For a free estimate, call (833) 508-9953. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Why Midwood Homeowners Call Chimney Sweep Canarsie for Chimney Sweep
Midwood’s chimneys fall into a category that gets mishandled constantly: soft, locally made brick from the 1910s to the 1930s that was later wrapped in stucco or parged. That combination traps moisture against the brick and lets freeze-thaw cycles do slow damage, and it’s a pattern we see across the neighborhood rather than the occasional outlier. Serving Midwood keeps us close to neighbors in Flatbush and Sheepshead Bay too, and the calls that come in tend to sound similar once you’ve done the work here a while.
What earns repeat calls in Midwood is naming materials instead of guessing. We work with DuraFlex flexible liner systems, HeatShield flue resurfacing, and caps from Gelco, Famco, and Copperfield. Our technicians have up to 8 years of experience. When we find a problem, we show it to you on camera before recommending anything, and the same company that inspects is the one that repairs.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Sweep Services in Midwood
Every service below reflects what Midwood’s housing actually needs, not a generic checklist. Our team handles the full lifecycle, from the firebox to the crown.
Level 1 Inspection
A Level 1 inspection is a visual check of the accessible chimney, firebox, and flue from the ground and the interior. For Midwood homes without a known problem, it’s the right starting point before a routine sweep. If we spot spalling brick or a parged exterior pulling away from the crown, we’ll recommend stepping up to a Level 2.

Level 2 Inspection
A Level 2 inspection goes further with a video camera run through the flue, and this is where Midwood’s piecemeal relining history shows up clearly. Decades of patchwork efforts leave mismatched flue tiles and gaps between sections, and a visual check alone won’t catch them. This inspection is standard when a home has changed hands or had an appliance replaced, and it’s the one that tells you what’s really inside the stack.

Creosote Removal
Third-degree creosote is the glazed, tar-like stage that a brush alone won’t remove. In Midwood, occasional fireplace use combined with damp, humid summers lets creosote settle and thicken rather than burn off clean. Removing it takes the right tools and, when the flue surface is damaged, a proper relining. Nothing gets scraped or replaced until you’ve seen it on camera.

Soot Removal
Our annual sweep covers soot as well as creosote, pulling buildup from the firebox, smoke chamber, and flue with drop cloths and controlled suction so nothing lands in your living room. Soot is the messier part of the job, and doing it right is what keeps the next season burning clean.
If you want the broader picture of what a full sweep involves, our chimney sweep team can walk you through it.
Trusted Brands We Service in Midwood
We name what we install so you know exactly what’s protecting your home. DuraFlex and HeatShield cover the lining and resurfacing side, while caps and covers come from Gelco, Famco, and Copperfield. For liner and venting components, we source through Olympia Chimney. Being clear about brands is how a homeowner can tell the difference between a professional repair and a hardware-store patch. When a Midwood chimney needs a fix, we tell you the product and the reason behind it.
Common Chimney Sweep Problems We See in Midwood Homes
The failures below come from the age, materials, and layout of Midwood’s housing rather than anything a single homeowner did wrong.
- Stucco and parged exteriors trapping moisture. The coating keeps water against soft vintage brick, so spalling and crown cracking often go unnoticed until a Level 2 inspection finds them.
- Mismatched flue tiles from piecemeal relining. Gaps between sections let creosote collect in hidden pockets, and that buildup is where third-degree creosote risk builds up over time.
- Shared flues in two-family houses. When the boiler flue runs year-round in the same stack as a fireplace, exhaust can backdraft through the damper and smell like a fireplace problem. A simple sweep won’t fix it.
- Deteriorating mortar crowns. Coastal humidity and freeze-thaw winters crack the crown, and once water gets in, the damage spreads down through the brick.
Why Midwood’s Shared Flues Are Their Own Problem
Here’s the detail that a generic chimney page misses. In Midwood’s two-family houses, the chimney often serves both the owner’s fireplace and the tenant’s boiler flue in a single stack. Because the boiler flue runs all year, what smells like a fireplace issue is frequently backdrafting from a blocked or undersized shared flue, pushing exhaust past the damper and into the living space.
A typical call goes something like this: a homeowner in a 1920s Midwood two-family notices a fireplace smell in the living room, even without a fire. A qualified technician typically finds the boiler flue is the real source, blocked or too small for the load, with exhaust backing down the fireplace side. Using a camera, the tech shows the mismatched flue tiles and a deteriorated mortar crown, then recommends relining the boiler flue and repairing the crown. No work gets done until the homeowner sees the evidence for themselves.
That is why we don’t recommend relining on a hunch. Camera inspection and a photo report come with the job, and we’ll openly tell you when a problem can wait versus when it needs attention soon.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Sweep in Midwood, NY
Typical pricing in Midwood runs $150 to $300 for a standard annual sweep, $200 to $350 for a Level 1 inspection with the sweep, and $300 to $550 for a Level 2 camera inspection. Fireplace cleaning on its own usually lands around $125 to $250, and creosote removal for heavier glazed buildup runs $350 to $700 depending on the flue’s condition.
What moves the price within those ranges is the number of flues on the stack, how accessible the roof is, and how much hidden damage the camera reveals. Because two-family Midwood homes often carry a shared stack, an inspection that covers both sides takes a bit longer. Every price is set per job by the written estimate, and estimates are free.
We Also Serve Cities Near Midwood
Midwood sits close to several neighborhoods we serve regularly, including Flatlands, Kensington, Flatbush, and Sheepshead Bay. The housing stock shifts a little block to block, but the pre-war brick and parged exteriors carry through most of these areas. If you’re just outside Midwood, we can still help.
Serving Midwood, NY – Our Local Coverage Area
We serve Midwood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Sweep in Midwood
A shared stack is the usual cause: the boiler flue runs year-round in the same chimney as your fireplace, and if it’s blocked or undersized, exhaust backdrafts down the fireplace side and smells like a fireplace problem. A camera inspection in the flue tells you which side is at fault. Call (833) 508-9953 for an exact quote.
Soft vintage brick wrapped in stucco or parged coating traps moisture, and Midwood’s freeze-thaw winters cycle that moisture through the brick until it flakes and the crown cracks. The damage hides behind the coating, so homeowners often don’t notice until an inspection or a leak. It’s worth a look before the next cold season.
Yes, occasional burning still leaves creosote, and humid Midwood summers let it settle and thicken rather than burn off. Annual sweeping plus a quick inspection catches buildup before it becomes glazed and hard to remove. Call (833) 508-9953 to book a sweep.
First-degree creosote is light, flaky soot that a brush handles easily; third-degree is glazed and tar-like, and a standard brush won’t touch it. In Midwood’s mismatched flue tiles, gaps trap creosote in hidden pockets, so buildup can reach the glazed stage without anyone noticing. That’s exactly the point where a camera inspection earns its keep.
Insist on seeing the evidence before anything is done. We show you camera footage and a photo report on the flue before recommending work, and we tell you plainly when a problem can safely wait. Nothing gets recommended without proof you can view yourself. Call (833) 508-9953 for a free estimate and a look inside your own stack.
Book Your Midwood Chimney Sweep
If your Midwood chimney has gone years without a sweep or an inspection, the camera tells you more in twenty minutes than a season of guessing. We work with DuraFlex, HeatShield, and caps from Gelco and Famco, and the same company that inspects is the one that repairs. Chimney problems don’t get cheaper when you wait. Call (833) 508-9953 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Canarsie.